 HomeNewsAluminum Plastic Panel Construction Technology(2)

Aluminum Plastic Panel Construction Technology(2)

2021-06-16

4. Install fireproof materials

High-quality fireproof cotton should be used, and the fire resistance period should meet the requirements of relevant departments. Fix the fireproof cotton with galvanized steel plate. The fireproof cotton shall be continuously sealed in the space between the floor and the metal plate to form a fireproof belt without any gap in the middle.

5. Install the aluminum plate

Use rivets or bolts to fix the aluminum alloy Aluminum Composite Panel Near Me finishes on the steel frame piece by piece according to the construction drawings. Leave 10~15mm seam between the board to adjust the installation error. When the metal plate is installed, the deviation between left and right, up and down should not be greater than 1.5 mm.

6. Deal with the Alumalite Sheet 4x8 seam

After cleaning the surface of the metal 3mm Aluminium Composite Panel and frame with a detergent, immediately place a sealing strip or weatherproof tape in the gap between the aluminum plates, and then inject materials such as silicone weather-resistant sealant. The injection should be full and there should be no gaps or gaps. bubble.

7. Deal with curtain wall Aluminium Composite Sign closing

In the closing process, the end of the wall panel and the keel can be covered by the metal plate.

8. Deal with deformation seams

To deal with the deformation joints, first of all, it must meet the needs of building expansion and settlement, and at the same time, it should also achieve a decorative effect. The heterosexual gold plate and neoprene belt system can often be used.

9. Clean the board surface

Remove the protective tape on the surface of the Fire Retardant Aluminium Composite Panel and clean the surface of the Acm Aluminum Composite Material.

Previous: Fluorocarbon Coating Aluminum Trim Has A Bright Future(1)

Next: Aluminum Plastic Panel Construction Technology(1)