Construction Technology Of Dry Hanging Bebond Acp Sheets Panels

1. The laying work is carried out according to the actual center line and elevation point of the civil construction; the design of the Alpolic Aluminum Composite Panels finish is based on the axis of the building. The 3mm Aluminum Composite Panel frame is composed of horizontal and vertical pieces. The anchor point of the vertical rod is determined.

2. Install the fixed connecting parts on the basis of laying out the wires, and fix the connecting parts by electric welding, with the anti-rust paint at the welding seam twice. The connecting Alucobond Aluminum Composite Panels piece is welded and fixed with the embedded piece on the main structure. When the embedded iron piece is not embedded on the main structure, the main structure can be drilled to install expansion bolts and fixed with the connecting iron piece.

3. Install the skeleton by welding. Check the elevation and centerline position at any time during the installation. At the same time, the cross-section connection welds are treated with anti-rust paint, and the fixed connection parts are concealed. The inspection records include the length, thickness, and position of the connection parts. Set the elevation, quantity, and embedding depth.

4. Install the Aluminum Composite Metal aluminum-plastic panel on the inner frame of the profile, first tap and mill the screw holes, and use rivets to fix the aluminum-plastic panel on the profile frame one by one; the gap between the panels is 10~15mm, and then silicone is injected Weather-resistant sealant; it is strictly forbidden to disassemble the packaging paper before the installation of the aluminum plate, until the protective film of the packaging is torn off before completion; construct according to the direction indicated by the arrow of the Pvdf Aluminium Composite Panel.

For the dry hanging of aluminum-plastic panels, first do the wall foundation, including angle steel, square tube, aluminum alloy square tube, and curtain wall special material. After completing the Aluminium Plastic Composite Sheet basics, calculate the size of the Black Aluminium Composite Sheet based on the size, and start processing the panel, which is called a plate in professional terms. First, the base material is taken out, the length and width of the base material are both 100px, and then a special edge trimming machine is used to repair the edge of the aluminum composite panel at 50px of each side at 2 times the thickness of the aluminum composite panel. Sew, cut off the excess part of each corner, and then fold the side over, be sure to form a right angle, fix it with a 1.5×1.5×1·125px aluminum seven-character angle, (drill the eye with a 4.2 drill bit, Rivet reinforcement). Now you can hang the tray. Use quick nails and special parts to fix the aluminum-plastic board on the wall foundation, leave the corresponding glue seam, and hang it from top to bottom.

It should be noted that the Acm Fascia Panels frame should be flat, vertical, and square, with a size error of about 5mm. The direction of the Arrowbond Aluminum Composite Panel should be consistent, and the error should be controlled at about 3mm. Glue should be applied from top to bottom, first fill it with a foam stick, then inject the glue, flatten it with a greasy knife, and tear off the protective film.

According to industry Aluminium Composite Seven standards, the thickness of aluminum-plastic panels is generally more than 3mm, and the aluminum thickness of 3mm aluminum-plastic panels is more than 10 wires (that is, 0.1mm). The aluminum-plastic panels used in indoor are generally 3mm, and the aluminum thickness is 10 wires, 15 Commonly used thicknesses such as silk and 21 silk are Willstrong Aluminum Composite Panel concentrated.